To increase your Wi-Fi coverage, you must finish the Linksys RE7000 Setup. You must switch on the extender, go to the Linksys RE7000 Setup page, and specify both the basic and advanced settings in order to accomplish this. Your network coverage will be enhanced and increased after this configuration is finished, reducing Wi-Fi dead zones.
Setup of Linksys RE7000 Extender with WPS
The easiest method to extend your host network is by utilising WPS. To set up your Linksys RE7000 extender, follow these straightforward instructions:
- Connect the extender to a power source, power it on, and allow it to initialise.
- Locate the WPS button on your Linksys RE7000 Extender, typically positioned on the front or side of the device.
- Press and hold the WPS button on the extender for approximately 2 seconds.
- The WPS LED light will begin flashing during this process.
- Once the process is complete, both the extender and router LEDs will stabilise.
Congratulations! You've successfully configured a Linksys RE7000 Extender using WPS. If you have any questions or require assistance with your extender, please don't hesitate to reach out to us for support.
No comments yet