Plastering an interior, exterior, or any other type of wall is easy with our detailed instructions. Plastering is a potentially dangerous activity, so it's important to prepare the floor and any nearby walls that won't be plastered by taping or covering them by Stucco Contractors NYC. As part of the getting ready process, you should inspect the plaster base. Before you begin plastering, make sure the wall is clean, solid, and dry.
First, get the wall ready to be plastered.
Priming a white brick wall is done by a skilled worker.
To begin with, there is the wall. Priming the wall will keep it from sucking the moisture out of the plaster, which will make it no longer hold. Keep take mind that different types of walls require different primers when making your purchase.
Plastering red brick walls requires that they be wet first. Apply the water to the wall using a paintbrush or spray bottle. Do not be bashful; a properly moist wall is the only one that can properly absorb plaster. For these brick walls, a separate primer is not necessary.
The second step is to mount the plaster profiles and corner rails on the wall.
Before you do anything else, secure the corner rails to the outside boundaries of your space, such as the edges around the windows. When cutting the rails, tin snips work well. After applying many "chunks" of plaster profile mortar to each corner, the next step is to press the corner profiles into the plaster, align them using a spirit level, and then fix them by Stucco Contractors NY. Use a trowel to smooth off any excess mortar and remove it.
Just like the corner rails, the plaster profiles are fastened. Plastering rails should be pressed into position with a straightedge every 90 to 100 cm on the wall to ensure that the plaster is applied evenly and plumb. Use a stripping strip that is somewhat longer than the distance between the profiles when you need to remove it later.
The profiles must be perfectly straight to achieve a straight-plastered wall. This can be facilitated by a spirit level.
Third, combine the plaster.
An electric mixer is used by a craftsman to mix plaster.
The plaster has to be mixed before it can be applied to the wall. Following the directions on the packaging, combine the plastering mortar you bought with a big basin of clean water. A spoon or ladle will do the trick for a tiny quantity. Using a drill mixer (or, even better, a specialized rental tool with higher power but is gentle on the drill chuck of your drill) to mix the plaster until smooth will prevent lumps from forming when using a larger quantity. To remove any remaining lumps, the mixture is vigorously agitated. After a few minutes of repose, stir it one more. You can plaster the wall correctly now that the plastering material has the correct consistency.
Keep in mind that plaster takes time to harden. Be careful not to mix more plaster in one hour than you can manage.
Fourth Step: Apply Plaster
A master craftsman generously coats the surface with plaster.
At last, the plastering can start! Applying plaster using a trowel or spatula and smoothing it out is sufficient if all that's needed to fix is some uneven sections on the wall. Plastering with a trowel can take some practice, though, as you need to fill greater gaps in walls or even plaster a whole wall.
Use a plaster trowel to apply the plaster coating. Applying plaster to a wall requires a trowel and some velocity, followed by a rough smoothing with the trowel. A touch more plaster will do the trick. In this case, a smoothing disk is also an option. Maintain a slight flush between the plaster and the plaster strip by Stucco Contractors NYC.
No comments yet